ElecGear Replacement Joystick & Drift Fix PCB Kit for PS5/PS4/Xbox/Switch Pro Controllers - ALPS & FU Analog Stick Sensor (Models EL1-EL7) - Perfect for Gaming, Repair & Controller Maintenance

Features

[EL3 for Switch Pro Controller] – 4x replacement analog joystick work with Nintendo Switch Pro and some PS3 controllers. The thumbstick module was made by ALPS. This RKJXV stick controller series comes with 10KΩ trimmer potentiometers

[Compatibility] – This version of analog stick comes in dark gray bottom plate with two plastic sticks inserting in the PCB. It locks in 3 directions when not sit in controller cover. The trim pot resistors can be in green or black. It is widely used in Switch Pro controller. Some reported it is also used in 8Bitdo SNES controllers

[4x Additional Drift Fix PCB] – Several factors cause joystick drifting a common issue. Even new joysticks can drift. The potentiometer was born without precision. Wear to the carbon film, spring fatigue and material stretching made it not centered. Dust, moisture and drop make it worse. We packed 4x PCB to fix the problem of drifting in one direction. Simply adjust the variable resistor to eliminate the drifting

[When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldn't center after years of wear and tear. The OEM genuine repair parts ensure accuracy and prolong lifespan

[Reminder of DIY] – With as many as 14 prongs, de-soldering and soldering the whole module takes serious skills. We suggest replacing the potentiometers first to solve most of the joystick problems. If you plan to take off the entire joystick module off PCB, we suggest two methods: 1.Take a look at the desoldering kit at product ID: B0BK7169M8. 2.or you can cut the 14 prongs one by one with a wire cutter